PAGE COUNT RESET HP COLOR LASERJET PRINTER 3000 / 3600 / 3800

Total page count

The page count that is stored in NVRAM and printed on the configuration page represents the number of pages that the formatter has formatted (not including engine-test prints). If you install a new formatter when repairing a printer, use this menu item to reset the page count to the previous value. In this way, the page count reflects the number of pages that the engine has printed rather than restarting the count for the new formatter. The page count is in two categories: total mono pages and total color pages.

NVRAM initialization
  • HP Color LaserJet 3000 printer
  • HP Color LaserJet 3000n printer
  • HP Color LaserJet 3000dn printer
  • HP Color LaserJet 3000dtn printer
  • HP Color LaserJet 3600 Series printer
  • HP Color LaserJet 3800 Series printer
Caution All HP Jetdirect settings are also reset. Be sure to print a configuration page before performing an NVRAM initialization. Make note of the IP address that is listed on the Jetdirect configuration page. You need to restore the IP address after performing an NVRAM initialization. Performing an NVRAM initialization resets the following settings and information:
  • All menu settings are reset to factory default values.
  • All localization settings, including language and country/region, are reset.
After performing an NVRAM initialization, reconfigure any computers that print to this printer so that the computers can recognize the printer.

To perform an NVRAM initialization
  1. Turn the printer off and then on.
  2. When the printer begins its initialization sequence, press [DOWN] and hold until all LEDs are lit.
  3. Press[UP] one time, and then press Menu.
Related Post

0 Response to "PAGE COUNT RESET HP COLOR LASERJET PRINTER 3000 / 3600 / 3800"

Post a Comment