FORD ACCEL DIGITAL FUEL INJECTION INSTALLATION MANUAL

Download Free Ford ACCEL Digital Fuel Injection Installation Manual.pdf Although this package is designed to allow you to convert a carbureted engine to fuel injection or allow you better control over your present fuel injected engine, it does not include the hydraulic portion of the installation. If you need a fuel pump, filter, fittings, etc. contact your local ACCEL EMIC center for the proper ACCEL DFI part numbers for your application.

Prior to installing your manifold make sure that all gasket surfaces are clean. ACCEL recommends using a 180 degree thermostat in most applications. Place your thermostat and gasket onto your manifold, put your thermostat housing onto the manifold and bolt in place. When installing your fuel injectors, be careful not to cut the O-Rings. A small amount of oil on each O-Ring will aid in the assembly. Please reference a service manual for proper torque
sequence and vacuum line routing. If this is a custom manifold, please contact your fabricator for this information.

The ECM comes with three (3) mounting tabs designed for a #8 sheet metal screw. It is recommended that you mount the ECM in the passenger side kick panel. If the kick panel has an air vent incorporated into it, DO NOT mount the ECM here. This unit is not waterproof and therefore needs to be mounted in a location free of moisture. The alternate locations are in the dash board and behind the glove box.

Download

0 Response to "FORD ACCEL DIGITAL FUEL INJECTION INSTALLATION MANUAL"

Post a Comment