Download Free 1996 Volkswagen Golf D Adjustments.pdf Start and warm engine to normal operating temperature. Ensure engine oil temperature is 176øF (80øC). Ensure A/C and electrical loads are off, including radiator cooling fan. Connect Engine Analyzer (VAG 1367) to engine. Connect Scan Tester (VAG 1551) to Data Link Connectors (DLC), located under A/C-heater system control panel. Ensure no Diagnostic Trouble Codes (DTC) are stored. Ensure throttle cable is properly adjusted. Ensure exhaust system has no leaks. Start engine and let it run for 2 minutes at closed throttle. Operate scan tester and observe display. Press "1" button to select RAPID DATA TRANSFER function. Press "0" and "1" buttons to select ENGINE ELECTRONICS function. Press "Q" button to enter input.
Press right arrow button, then "0" and "4" buttons to select BASIC SETTING function. The Engine Control Module (ECM) should control idle speed and close fuel evaporative frequency valve. Press "0" and "1" buttons to select DISPLAY GROUP NUMBER 1 input. Press "Q" button to enter input. Scan tester displays idle speed in field one, oxygen sensor factor (fluctuating 0.75-1.25) in field three, and ignition timing in field four. When radiator cooling fan stops running, end BASIC SETTING function by pressing right arrow button. Press "0" and "6" for END OUTPUT function. Press "Q" button to enter input. If idle speed, CO level or ignition timing is incorrect, turn ignition off. Check accelerator pedal and throttle cable for ease of operation. Disconnect ECM and reconnect. Test drive vehicle and check for DTCs. Repeat engine basic setting function.
Download
Press right arrow button, then "0" and "4" buttons to select BASIC SETTING function. The Engine Control Module (ECM) should control idle speed and close fuel evaporative frequency valve. Press "0" and "1" buttons to select DISPLAY GROUP NUMBER 1 input. Press "Q" button to enter input. Scan tester displays idle speed in field one, oxygen sensor factor (fluctuating 0.75-1.25) in field three, and ignition timing in field four. When radiator cooling fan stops running, end BASIC SETTING function by pressing right arrow button. Press "0" and "6" for END OUTPUT function. Press "Q" button to enter input. If idle speed, CO level or ignition timing is incorrect, turn ignition off. Check accelerator pedal and throttle cable for ease of operation. Disconnect ECM and reconnect. Test drive vehicle and check for DTCs. Repeat engine basic setting function.
Download
0 Response to "1996 VOLKSWAGEN GOLF D - ADJUSTMENTS"
Post a Comment