Welcome to the iPod nano Take-Apart manual. Nanos are small and fragile, so you have to handle them with care. The inside is pretty much one piece including the logic board, battery (which is soldered on), RAM (2 or 4GB), headphone jack, and data port.
There is one slight difference between the design of the 2GB and 4GB models. The 2GB model in the revisions seen so far have a socketed daughterboard. This allows for easy replacement of the RAM by just removing a couple of screws. The 4GB models have the RAM chip soldered directly to the logic board making it nearly impossible to change RAM chips without the proper soldering equipment. This manual will show a comparison between the two models a little bit later.
Table contents of iPod Nano Take Apart Service Manual
There is one slight difference between the design of the 2GB and 4GB models. The 2GB model in the revisions seen so far have a socketed daughterboard. This allows for easy replacement of the RAM by just removing a couple of screws. The 4GB models have the RAM chip soldered directly to the logic board making it nearly impossible to change RAM chips without the proper soldering equipment. This manual will show a comparison between the two models a little bit later.
Table contents of iPod Nano Take Apart Service Manual
- Opening the Case
- Removing the Logic Board
- Removing the RAM module
0 Response to "IPOD NANO TAKE APART SERVICE MANUAL"
Post a Comment